11.1.2  
Card Configuration | T1 Configuration 
 


System Status | System-wide | Card Config. | T1 Configuration
 
T1 Configuration is displayed by clicking on the Card Config. button in the Cards tab.
With T1 Configuration, port allocation to lines or stations can be performed for analog T1 cards plugged in the communication system.

11.1.2.1  
Area: Card configuration, Slot 
The Slot selection list contains the T1 cards (analog or digital) installed in the communication system together with the slot IDs.

11.1.2.2  
Area: Port assignment, Port, Type 
Assistant E Office supports port allocation of analog T1 cards to lines or stations. To do this, the corresponding ports are selected from the Port selection list and the Type line or station is allocated. The selected ports are then assigned by clicking Assign.
CAUTION: Configuration of an analog T1 card must be implemented very carefully because the card can be damaged by incorrect configuration. Consequently, reconfiguration can only be achieved in a roundabout way. Select Cards. You can now unplug the card from the communication system and insert it again from here. You can then reconfigure the ports. But remember, this will not be enough if the card was already configured in the communication system. If the card was already configured in the system, you must put it out of service via Assistant T and then back into service again before you generate the communication system's database. In addition, the option Transfer | CommunicationHardware must be activated via . This will cause a restart after generation and will set up the ports on the card correctly.  

See also:  
   -   Section 11.1.1 "Cards"
   -   Section 11.1.3 "Card Configuration | Card data"

HiPath 3000/5000 V9, Manager E, Administrator Documentation, Issue 10   up Top
Disclaimer & Copyright   ID: P31003H3590M1000176A9   2014-03-03