5.1.3  
Carrying Out a System Reload 
 
After supplying the system with power, you must carry out a system reload.

Procedure  
The reset/reload switch is tested by a Field Programmable Gate Array (FPGA). This FPGA is loaded by the processor when starting up the HiPath 3800 and is only fully functional after the loading process is complete. If the reset/reload switch is activated during loading, then it is not possible to evaluate the cause of the restart. For this reason, the reset/reload switch may only be activated after the system startup (green Run LED lights up).  
Press and hold down the reset switch for at least 5 seconds (FAIL LED (red) goes out). If you do not hold down the reset switch for a full 5 seconds, the system may perform a reset rather than a reload or may not reload properly.

HiPath 3000/5000 V9, Service Documentation, Issue 7   up Top
Disclaimer & Copyright   ID: P31003H3590S100017620   2012-06-25