3.2.2  
Individual Telephone Lock (Changeover) 
 

Definition  
Users can activate a telephone lock that restricts outgoing external calls (COS 1), although they can continue to place internal calls and forward incoming calls to internal stations. Users activate the telephone lock by pressing a key or dialing a code and entering their 5-digit personal identification number (PIN).
System speed dialing remains active while the telephone lock is on.
The PIN must be configured first; only digits 0-9 are allowed. The default PIN is set at 00000 for all telephones. If the user has forgotten the PIN, the PIN can be reset to the default value 00000 by the HiPath 3000/5000 Manager E or by the Attendant position (station 10/100).
While the Telephone Lock feature is activated, the user can only use the following features:
 •   System speed-dialing
 •   Room Monitor
 •   Speaker call
 •   Internal calls
 •   Conferences with internal stations
The function #0=Reset all services does not deactivate this feature. It is not possible to change the PIN from a locked telephone. This PIN is the same PIN that a user must enter when entering the system via Direct Inward System Access (DISA). The external user can activate/deactivate Individual Telephone Lock from a DISA connection, but the user cannot change the PIN from a DISA connection.

Model-Specific Data  

 Subject  
 HiPath 3800  
 HiPath 3550  
 HiPath 3500  
 HiPath 3350  
 HiPath 3300  
Feature available in  
 x  
 x  
 x  
Hardware requirements  
 -  
 -  
 -  
Software requirements  
 V5.0 or later  
 V1.0 or later  
 V1.0 or later  

Dependencies/Restrictions  

 Subject  
 Dependency/Restriction  
Extension trunk access  
After telephone lock is activated, the extension trunk access is set to a system-wide class of service (default = 1).  
Extension trunk access  
When the lock code is activated, you can restrict the class of service but not select a higher class of service.  
Telephone lock  
While telephone lock is active, you cannot activate any features that could result in charges being assigned to this station. Exception: system speed dialing.  
Telephone type  
This feature works with any type of telephone in the system.  
Non-display/analog feature reminder  
Upon going off-hook, broken dial tone is presented to the user as a reminder that a feature is active on the telephone.  
Invoke from a talk state  
During a conversation, the user presses the Consultation key (or performs a switch hook flash in the case of an analog telephone), putting the current conversation on Consultation Hold. The user then dials the access code and the PIN and confirmation tone is returned. The user can then return to the held party by pressing the Consultation key once again.  

HiPath 3000/5000 V9, Feature Description, Issue 7   up Top
Disclaimer & Copyright   ID: P31003H3590F100017618   2012-06-25