 |
|
3 |
Features for General Traffic |
3.1 |
Features for General Incoming Traffic |
3.1.1 |
Distinctive Ringing |
| Implementing features, see also Manager E Distinctive Ringing |
Definition |
| Distinctive tones indicate different call types. This enables the user to distinguish between incoming internal and incoming external calls. In ISDN systems, acoustic information is secondary to displays on the screen because different features can have the same ring signaling. |
| In V6.0 and later, call signaling that varies from caller to caller is also possible. |
| In addition to external call signaling, it is also possible to configure internal call signaling for each station. Every internal call made by this station (calling station) is signaled by the ring type on station B (called station). The ring frequency at the destination depends on the caller's ring frequency. This is implemented by allocating a specific ring frequency to a station via Manager E. As with the existing field for external calls ("Call signaling"), the new internal call frequencies are controlled by Manager E (and not by Manager C). |
| The different ring frequencies are applied to the called stations in the case of station type HFA (UP0/E or IP). Analog stations are always called using frequency 1. |
| The different internal ring frequencies only function between end points that are registered in the same system or node. |
| Seven additional ring frequencies are added to the existing ring frequency. These frequencies will have different default values, whereby each station is displayed with frequency 1 by default. |
CMI handsets |
| Gigaset 7000 and Gigaset SL1 will support CLIP in V6.0 SMR-07 or later. CLIP information will also be transmitted to the Gigaset over a DECT information element for this. |
| Gigaset 7000 supports the VIP ring feature that applies a special ring signal (Gigaset software 22.041). For this to work, individual ring tones must be defined for phonebook entries in the internal phonebook in Gigaset 7000 (for example, SL55). Callers are identified on the basis of the CLIP information received. |
| Only handsets with ring melodies are supported. The calling number ID is sent to the Gigaset so that the melody selection function in the internal phonebook (VIP) is supported; this depends on whether this feature is supported by the relevant caller. |
| The various internal ring frequencies only operate between endpoints that are registered in the same system or node. |
| Seven additional ring frequencies are added to the existing ring frequency. These frequencies will have different default values, whereby each station is displayed with frequency 1 by default. |
Acoustic signaling |
| Depending on the telephone, three different types of acoustic signaling are possible: |
| • | for optiPoint 500 and OpenStage CorNet-IP (HFA) telephones: |
| - | Ring type 1 = External call CO (for example, double ring) |
| - | Ring type 2 = External call CO 2 (for example, triple ring) |
| - | Ring type 3 = External call CO 3 (for example, short/long/short) |
| • | for analog telephones (only for Germany): |
| - | Ring type 1 = External call CO (for example, double ring) |
| - | Ring type 2 = Recall |
| - | Ring type 3 = Door bell ring |
| • | for analog telephones (not for Germany): |
| - | Ring type 1 = External call CO (for example, double ring) |
| - | Ring type 2 = External call CO (for example, double ring) |
| - | Ring type 3 = External call CO (for example, double ring) |
| The ring cadences depend on the country. |
Model-Specific Data |
| |
Dependencies/Restrictions |
| |
| HiPath 3000/5000 V9, Feature Description, Issue 7 | up  |
|
|
||
| Disclaimer & Copyright | ID: P31003H3590F100017618 | 2012-06-25 |