Chapter	Description
Chapter 1 "Introduction and Important Notes"	This chapter contains the basic information necessary for working with the product and with this service documentation. The safety information and warnings as well as the standards and guidelines regarding installation, including lightning protection, must be observed!
Chapter 2 "System Data"	This chapter provides information on the current HiPath 3000/5000 version and associated systems (characteristics, construction, system environment, capacity limits, technical data).
Chapter 3 "Boards for HiPath 3000"	This chapter describes all of the boards used for HiPath 3000. The hardware information (such as connection cables and NT connections) is presented for each board.
Chapter 4 "Installing HiPath 3000"	The actions necessary for the standard installation (part of a standard system) of the different HiPath 3000 systems are described in this chapter.
Chapter 5 "Starting Up HiPath 3000"	The procedures for the startup of the individual HiPath 3000/5000 systems and components are described in these chapters.
Chapter 6 "Startup and Administration HiPath 5000"
Chapter 7 "Starting HiPath 3000 as a Gateway"
Chapter 8 "Licensing"	This chapter contains information about HiPath License Management.
Chapter 9 "Expanding and Upgrading HiPath 3000"	Information on supplementary equipment and expansions and on the procedure for upgrading HiPath 3000 systems are part of this chapter.
Chapter 10 "Workpoint Clients"	This chapter contains the description of the workpoint clients supported.
Chapter 11 "HiPath Cordless Office"	Basic information about the operation of the HiPath Cordless Office are part of this chapter.
Chapter 12 "Service"	This chapter describes service and maintenance tasks and provides information on error detection and troubleshooting.
Chapter 13 "HiPath 3000/5000 in the LAN Network"	This chapter contains information on the topic of IP.
Appendix A "System Programming Codes (Expert Mode Codes)"	These appendices contain lists with programming codes, IP protocols, port numbers.
Appendix B "Codes for Activating/Deactivating Features"
Appendix C "IP Protocols and Port Numbers Used with HiPath 3000/5000 V7 and Higher"
Appendix D "Identifying System Power Requirements"	This supplement provides information on the power requirement of the boards and components of the HiPath 3000 systems.
Appendix E "Notes for Editing the File snmpd.cnf"	This appendix is aimed at users with sufficient SNMP knowledge to modify trap destinations and community names in HiPath Fault Management Desktop.
Appendix F "Country Versions"	This appendix specifies the countries with a separate country code and the countries with the country code "IM" that can be set in Manager E for configuring HiPath 3000/5000.