1.2.6 |
Notes |
| Note the following information in order to avoid damage to property: |
| • | Before placing the system into operation, check whether the nominal voltage of the power supply network corresponds to the nominal voltage of the communication system or device (type plate). If necessary, adjust the nominal voltage of the communication system or device appropriately. |
| • | To protect electrostatically sensitive devices (ESD): |
| - | Always wear the wristband in the prescribed manner before performing any work on PC boards and modules. |
| - | Transport PC boards and modules only in suitable protective packaging. |
| - | Always place PC boards and modules on a grounded conductive base, and do not work on the PC boards anywhere else. |
| - | Only use grounded soldering irons. |
| • | Use only original accessories. Failure to observe these instructions may damage the equipment or even violate safety and EMC regulations. |
| • | Before starting wall mounting, check that the wall has sufficient bearing strength. Always use suitable installation and mounting materials to mount the communication systems and devices securely. |
| • | Condensation damage: A sudden temperature change may cause condensation to form. If the communication system or device is, for example, moved from a cold environment to a warmer space, condensation may form. Wait until the temperature has regulated and the communication system or device is completely dry before switching it on. |
| HiPath 3000/5000 V9, Service Documentation, Issue 10 | up |
|
|
||
| Disclaimer & Copyright | ID: P31003H3590S100017620 | 2014-02-27 |