9.1.4  
Connecting Special Equipment 
 

9.1.4.1  
Entrance Telephones 

Connection options  
 Figure 9-7   Connection Options for Entrance Telephones
 
The new central control boards CBCC (S30810-Q2935-A301) and CBRC (S30810-Q2935-Z301) only support TFE-S-Adapter S30122-K7696-T313.  
You can also make a direct connection if needed. In this case, only voice connections to the entrance telephone are possible, without the support of the opener and signal functions.
 Figure 9-8   Direct Connection of Entrance Telephones
 

9.1.4.1.1  
Information on Third-Party Entrance Telephones 

DoorCom Analog  
General information
The plus product DoorCom® Analog is a universal entrance telephone adapter box for Siedle entrance telephones (such as the Vario TLM 612). It is released for use with all HiPath 3000 systems, V1.2 and later.
It is connected to an analog port in the system. DoorCom Analog behaves like an analog telephone (DTMF tone dialing, detection, and control). It can be operated with DTMF signals.
DoorCom Analog can function only in combination with the following components:
 •   DoorCom Analog DCA 612-0
 •   Siedle-Vario TLM 612 entrance telephone
 •   Switching remote control interface DCSF 600
For the voice connection of an internal user to the entrance telephone: Without this module, it is not possible to call back to the entrance telephone, for example, if a call was unintentionally cleared down by the entrance telephone.)
 •   Power supply NG 602-0
Connection
 Figure 9-9   Connecting DoorCom Analog to HiPath 3000
 
Configuration notes for HiPath 3000/5000 Manager E
DoorCom Analog  
Set up station: Stations: Parameters:  
Extension Type = Standard  
Flags = Call waiting rejection on  
System parameters:  
Flags = DTMF automatic  
Remote station (telephone)  
Set up station: Stations: Parameters:  
Flags = Call waiting rejection off  
Flags = Missed Calls List  
Device control features (open doors, select entrance telephone, etc.) can be programmed on procedure keys. The stored DTMF signal sequence is sent to the application.

9.1.4.2  
Connecting Speakers 
You have the following options:
 •   Connection to an analog station port (the amplifier may require level adaptation)
 •   Connection to an analog station port over an ET adapter
Note: The ET adapter requires a 12V power supply (DC or AC).
 •   Connection to an analog trunk circuit

Connecting speakers to an analog station port  
 Figure 9-10   Connecting Speakers to an Analog Station Port
 

Connecting speakers to an analog trunk port  
 Figure 9-11   Connecting Speakers to an Analog Trunk Port
 

HiPath 3000/5000 V9, Service Documentation, Issue 10   up Top
Disclaimer & Copyright   ID: P31003H3590S100017620   2014-02-27