6.5.5  
Installing the TAPI Service Provider 
 
This section describes the separate installation of the TAPI 170 Service Provider.
You will find detailed information on how to install and configure the individual installation components in the online help for the TAPI 170 Service Provider.
 1.   Insert the TAPI 170 Service Provider installation CD and run Setup.
 2.   Confirm the welcome dialog by clicking Next.
 3.   The Setup Type dialog appears. The following options are available:
   •  Standalone
For using the TAPI Service Provider in standalone scenarios with no more than one HiPath 3000 system.
   •  AllServe
For using the TAPI Service Provider in networked HiPath AllServe scenarios.
   •  HiPath 3000/5000 V4.0
For using the TAPI Service Provider in networked HiPath 3000/5000 scenarios in V4.0 and later.
   •  User-defined
In this case you can manually select the components to be installed.
    When you select the setup types Standalone, AllServe and HiPath 3000/5000 V4.0, the required installation components are automatically preselected.
   
 Setup type  
 Installation component  
 TAPI Service Provider TSP  
 CSTA Message Dispatcher CMD  
 CSTA Service Provider CSP  
 Dongle driver1  
 Central Configuration Manager Client CCMC  
Standalone  
 X  
 -  
 -  
 -  
 -  
AllServe  
 X  
 -  
 -  
 -  
 X  
HiPath 3000/5000 V4.0  
 X  
 X  
 X  
 -  
 X  
1The dongle driver is only relevant to installations for which a dongle is used for licensing. When reinstalling TAPI 170 Version 2.0 or later, MAC IDs and license codes are used for the licensing procedure. The dongle driver is therefore not required.
 4.   Select the appropriate option and confirm with Next.
 5.   The system starts to install the selected components.
   
At the beginning of the installation routine (the precise time will depend on the installation components you selected), a dialog is displayed prompting you to enable ACD support. Confirm this prompt with Yes.  
The relevant ACD support utility can also be enabled or disabled at a later stage. For further information, please refer to the online help for the TAPI 170 Service Provider.  
    When a component is successfully installed, the associated configuration dialog opens. You can set the required parameters here or postpone configuration until a later time.
 6.   When all of the selected components have been installed, a final dialog is displayed in which you can conclude installation with Finish.
The TAPI Service Provider is now installed.

HiPath 3000/5000 V8, Service Documentation, Issue 10   up Top
Disclaimer & Copyright   ID: P31003H3580S100017620   2011-01-24