3.4.4  
ANI4R (for selected countries only) 
 
NOTE: Danger of damage to property due to surge voltage. The required lightning protection measures must be taken for this board, see Section 2.1.2 "Lightning Protection".  

Introduction  
The ANI4R (Automatic Number Identification Rack) board is responsible for receiving station numbers modulated using the CPFSK method, demodulating them, and forwarding them to the HiPath 3500 or HiPath 3300 base system. In V4.0 SMR-7 or later, the station name is analyzed in addition to the call number and shown on the telephone display.
Each ANI4R module can serve four trunks. It contains the external trunk board hardware interfaces (TMGL4R) and the options bus interface.
If ANI4R is installed as option 1 or 2, TMGL4R board must be inserted in slot 4, 6 or 8 (slots 6 and 8 not available with HiPath 3300).  

Interfaces  
 Figure 3-139   ANI4R (for selected countries only) (S30807-Q6917-Z103)
 

Contact assignment  

 Table 3-181   ANI4R (for selected countries only) - Contact Assignment
 X3 Pin  
 Signal  
   
 X3 Pin  
 Signal  
 1  
 -  
   
 6  
 a-wire (tip), trunk 3  
 2  
 a-wire (tip), trunk 1  
 7  
 b-wire (ring), trunk 3  
 3  
 b-wire (ring), trunk 1  
 8  
 a-wire (tip), trunk 4  
 4  
 a-wire (tip), trunk 2  
 9  
 b-wire (ring), trunk 4  
 5  
 b-wire (ring), trunk 2  
 10  
 Call charging module assignment (GMZ)  

HiPath 3000/5000 V8, Service Documentation, Issue 10   up Top
Disclaimer & Copyright   ID: P31003H3580S100017620   2011-01-24