3.4.2  
AMOM 
 

Introduction  
AMOM is an opto-electronic converter that can be used to connect fiber optic cables to the Sub-D jacks on the front panel of the DIU2U, DIUN2, and DIUT2 boards.
 Figure 3-136   AMOM - Connection to DIUN2, DIU2U, and DIUT2
 

AMOM variants  

 AMOM variant  
 Wave length  
 Op.fiber cable  
 Cable length  
 (km)  
 Cable attenuation  
 (dB/km)  
 Maximum attenuation1  
 (dB)  
S30807-K5480-X100  
850/820 nm  
multimode  
50 µm  
62.5 µm  
 2,5  
 3  
 3  
 3,5  
 11,5  
 14,5  
S30807-K5480- X200  
1300 nm  
multimode  
50 µm and 62.5 µm  
 6  
 1  
 10  
S30807-K5480- X300  
1300 nm  
mono mode  
9 µm/125  
 8  
 0,5  
 8  
1Maximum optical attenuation in an AMOM to AMOM connection: a reserve of 4 dB attenuation must be included for ageing and splicing.

Connector assignment  

 Table 3-178   AMOM - 15-Pin Sub-D Plug Assignment
 Pin  
 Signal  
 Signal description  
 Direction  
 4  
LWLO0_FRONT  
Data output on the optical fiber interface  
Input  
 5  
GND  
Ground return path for the +5-V power supply  
Input/output  
 6  
SCAN_IN0  
Adapter test  
Output  
 7  
SCAN_IN0  
Adapter test  
Output  
 10  
+ 5 V  
+5-V power supply  
Input  
 11  
LWLI0_FRONT  
Data input on the optical fiber interface (front)  
Output  
 12  
GND  
Ground return path for the +5-V power supply  
Input/output  
 14  
+ 5 V  
+5-V power supply  
Input  
 No other pins used.  

HiPath 3000/5000 V8, Service Documentation, Issue 10   up Top
Disclaimer & Copyright   ID: P31003H3580S100017620   2011-01-24