10.1.7 |
Forwarding |
| Forwarding only displays station-specific (no system-specific) status information. Under Call forwarding you can see whether the station has been forwarded to another station or is itself a call forwarding destination. As of Hicom 150 H V1.0/Hicom 150 E Office Rel. 3.0, forwarding for MULAPs is also displayed. |
10.1.7.1 |
Table: Stations/MULAP |
| All stations available in the communication system are entered in the Stations/MULAP table (also MULAPs as of Hicom 150 H V1.0/Hicom 150 E Office Rel. 3.0). When stations are selected in the table, any relevant call forwarding information for them will be displayed under Call forwarding or Ringing group on. |
10.1.7.2 |
Area: Call forwarding |
Status, Forwarding destination from |
| One of three call forwarding types may be set in the station. The three types are: |
| - | External |
| - | Internal |
| - | All |
| The type selected at this station/MULAP is displayed in Status. If forwarding has not been activated at that station/MULAP, the status is indicated as Off. |
| The Forwarding destination from text box lists the stations/MULAPs that are forwarded to this station/MULAP, if these stations are internal. |
10.1.7.3 |
Area: Ringing group |
| All stations to which the station selected earlier in the Stations/MULAP table transferred calls (Stations included), and stations which also transferred calls to the selected station (Connection of), are displayed. |
Group ringing with external destinations |
| Example: In a HiPath 5000 PCS, there are registered IP telephones that dial to CO via a HiPath 3800 hub. When the group ringing flag is activated (on), the external telephone should ring in parallel. |
| In order to be able to use this feature, another CO code, other than 0, must be created in the transit hub (HiPath 3800). In the least cost routing of the HiPath 5000 PCS, the 0 CO code dialed there must be converted using a dialing rule into the additional CO code for the HiPath 3800. |
| Also, the flag External traffic transit must be set in the transit hub (HiPath 3800). |
Stations included |
| The user can forward calls to up to five stations. If another station has forwarded calls to this station, then that station is shown here too. |
Connection of |
| Shows whether or not calls were transferred to this station, and if so, from what device. |
| |
| HiPath 3000/5000 V8, Manager E, Administrator Documentation, Issue 11 | up  |
|
 |
||
| Disclaimer & Copyright | ID: P31003H3580M1000176A9 | 2011-03-18 |
