9.10.8  
Firewall | Edit IP firewall 
 


Settings | Network | Firewall | Edit IP firewall
 
To edit the parameters, double-click the corresponding table cell Firewall.

Source IP addr.  
The Source IP address to which the firewall should react. If this exact entry does not also turn up in the IP routing table, the remote station is classified as an individual host. If a routing entry exists for the IP address, the address type of the entry (network or host) is assumed.

Dest. IP addr.  
The Dest. IP address determines the network or host to which a connection may be made. A value of 0.0.0.0 authorizes a connection to any given IP address.

9.10.8.1  
Area: Protocol 

IP protocol  
This setting allows the IP packet that should pass through the firewall to be more precisely specified according to its protocol.
   -   All IP protocols
   -   TCP (Transmission Control Protocol)
   -   UDP (User Datagram Protocol)
   -   ICMP (Internet Control Message Protocol)
In order to be able to reach the applications in the communication system, the following table must be taken into account on activating the IP firewall:

Application  
IP protocol/IP port  
Command  
Telnet  
TCP, Port 23  
 
HiPath 3000 Manager  
TCP, Port 7000  
 
CSTA  
TCP, Port 7001  
 
Log  
UDP, Port 69 (TFTP)  
GET -i log.arc  
APS (APS transfer)  
UDP, Port 69 (TFTP)  
GET, PUT -i Hicom.fli  
Call detail recording  
UDP, Port 69 (TFTP)  
GET -i gez.txt, gel.txt, get.txt  
CDB  
UDP, Port 69 (TFTP)  
GET -i kds.txt  
ASCII  
UDP, Port 69 (TFTP)  
GET -i ascii.txt  

IP port, All ports allowed  
Which port is allowed can be indicated for TCP or UDP. It is also possible to select (and thus activate) All ports allowed.

ICMP type, All types allowed  
Which ICMP type is allowed can be indicated for ICMP. It is also possible to select (and thus activate) All types allowed.

ICMP code, All codes allowed  
Which ICMP code is allowed can be indicated for ICMP. It is also possible to select (and thus activate) All codes allowed.

9.10.8.2  
Area: Record no. 

Record no.  
The number of the entry is displayed next to Record no.:.

<, >  
The buttons < and > can be used to scroll between the IP firewall entries that are already configured.

New  
A new entry is set up using the button New.

9.10.8.3  
Back button 
Back returns you to Firewall. There the data entered can be finally applied or rejected.

See also:  
   -   Section 9.10.7 "Firewall"
   -   Section 9.10.9 "Firewall | Edit application firewall"

HiPath 3000/5000 V8, Manager E, Administrator Documentation, Issue 11   up Top
Disclaimer & Copyright   ID: P31003H3580M1000176A9   2011-03-18