9.6.7  
Groups/Hunt groups | External destinations 
 


Settings | Incoming calls | Groups/Hunt groups | External destinations
 
External destinations is used to enter call numbers in a subsystem and a CO. If group stations are also external stations, this group can be called by a station without CO call privileges. However, the external stations will be excluded.
External destinations can be included in a cyclical or linear hunt group, and entered in a no answer group. UCD groups and MULAPs cannot be used for this purpose.
A route must be entered for each external destination (call number). Otherwise, the applicable hunt group cannot be reached by call forwarding from an internal subscriber.  

9.6.7.1  
Area: Group 
The name and call number of the selected group is displayed.

9.6.7.2  
Members table 
All internal and external stations in a group are listed.

9.6.7.3  
Area: External destinations 
The external destination can be entered here, where the call number may contain up to 6 digits for seizing the line and 25 digits for dial information.

9.6.7.4  
Close button 
The Close button closes the dialog and returns you to the Groups/hunt groups tab. It is only on this tab that any changes that were made can be actually applied.

See also:  
   -   Section 9.6.4 "Groups/hunt groups"

HiPath 3000/5000 V8, Manager E, Administrator Documentation, Issue 11   up Top
Disclaimer & Copyright   ID: P31003H3580M1000176A9   2011-03-18