9.4.14 IP Trunks for HG 1500

9.4.14	IP Trunks for HG 1500

Settings | Lines/networking | IP Trunkseitungen

IP Trunks is used to configure the trunks for the inserted HG 1500 boards.

9.4.14.1

Area: Selection

Gatekeeper HG 1500

Under HG 1500 Gatekeeper, select the HG 1500 board plugged into the communication system that is configured as a gatekeeper (see also Settings | Set up station | Gatekeeper).

Enable gateway resources flag

This flag is used to free up the gateway resources from the gatekeeper card for the system.

9.4.14.2

Table: Trunks

The table shows all the lines that have been set up for the HG 1500 board.

Number, Add

The number of trunks to be newly configured are specified here. In total, up to 8, 16 or 64 trunks can be configured depending on the board. A higher number of trunks will be ignored.

These trunks must be assigned to the last route. See Settings | Lines/networking

Options:

•	In HiPath 3000 V5.0 and higher, trunks are no longer assigned on a group basis but on a system basis

•	In HiPath 3000 V6.0 SMR09 and later, you can choose between the following options when adding trunks:

SIP Provider 1 ... 4

Trunking

Ext. Registrar

Ext. Gatekeeper

Each of these options is assigned a separate route.

The Ext. Registrar option is needed when using the SIP protocol to connect to a communication system.

The Ext. Gatekeeper option is needed when using the H.323 protocol to connect to a communication system.

Selected line, Delete

All selected lines are deleted by pressing Delete.

Configured line

This field shows the number of trunks configured for the HG 1500 board.

Section 9.4 "Settings | Lines/networking"

Section 9.4.15 "IP trunks for SIP providers and OpenScape Office"

Section 9.10.15 "Gatekeeper"

Section 10.1.1 "Cards"

Section 10.1.2 "Card Configuration | T1 Configuration"

Section 10.1.3 "Card Configuration | Card data"

HiPath 3000/5000 V8, Manager E, Administrator Documentation, Issue 11		up

Disclaimer & Copyright	ID: P31003H3580M1000176A9	2011-03-18